1、網絡設備配置與調試項目三實施報告項目描述：熟悉交換機上VLAN的創建及相關配置，給公司各部門劃分相應的VLAN進行廣播風暴的隔離控制并進行相關測試。項目實施拓撲圖：項目實施基本要求：（1）正確選擇設備并使用線纜連接；（2）正確給各個PC配置相關IP地址及子網掩碼等參數；（3）在SW1上配置相關VLAN，并把交換機相應的端口添加到VLAN中。用相關顯示命令查看配置結果。（4）在SW2上配置相關VLAN，并把交換機相應的端口添加到VLAN中。用相關顯示命令查看配置結果。（5）在SW3上配置相關VLAN，并把交換機相應的端口添加到VLAN中。用相關顯示命令查看配置結果。（6）在SW4上進行相關配置，

2、使得不同交換機上的相同部門PC（如銷售部PC1和銷售部PC3）可以相互訪問。項目拓展要求（選做）：如何配置下面網絡拓撲圖中的兩個交換機，使得兩個不同VLAN中的PC能相互訪問。Switch>enSwitch>confSwitch>enSwitch#confConfiguring from terminal, memory, or network terminal? Enter configuration commands, one per line. End with CNTL/Z.Switch(config)#inSwitch(config)#VLAN 10Switch(c

3、onfig-vlan)#exitSwitch(config)#inSwitch(config)#interface raSwitch(config)#interface range f0/5Switch(config-if-range)#swSwitch(config-if-range)#switchport acSwitch(config-if-range)#switchport access vlan 10Switch(config-if-range)#exitSwitch(config)#exitSwitch#%SYS-5-CONFIG_I: Configured from consol

4、e by consoleSwitch#confConfiguring from terminal, memory, or network terminal? Enter configuration commands, one per line. End with CNTL/Z.Switch(config)#inSwitch(config)#interface raSwitch(config)#interface range f0/5Switch(config-if-range)#swSwitch(config-if-range)#switchport mode ? access Set tru

5、nking mode to ACCESS unconditionally dynamic Set trunking mode to dynamically negotiate access or trunk mode trunk Set trunking mode to TRUNK unconditionallySwitch(config-if-range)#switchport mode % Incomplete command.Switch(config-if-range)#? cdp Global CDP configuration subcommands channel-group E

6、therchannel/port bundling configuration channel-protocol Select the channel protocol (LACP, PAgP) description Interface specific description duplex Configure duplex operation. exit Exit from interface configuration mode mdix Set Media Dependent Interface with Crossover mls mls interface commands no

7、Negate a command or set its defaults shutdown Shutdown the selected interface spanning-tree Spanning Tree Subsystem speed Configure speed operation. storm-control storm configuration switchport Set switching mode characteristics tx-ring-limit Configure PA level transmit ring limitSwitch(config-if-ra

8、nge)#swSwitch(config-if-range)#switchport ? access Set access mode characteristics of the interface mode Set trunking mode of the interface native Set trunking native characteristics when interface is in trunking mode nonegotiate Device will not engage in negotiation protocol on this interface port-

9、security Security related command priority Set appliance 802.1p priority trunk Set trunking characteristics of the interface voice Voice appliance attributesSwitch(config-if-range)#switchport ? access Set access mode characteristics of the interface mode Set trunking mode of the interface native Set

10、 trunking native characteristics when interface is in trunking mode nonegotiate Device will not engage in negotiation protocol on this interface port-security Security related command priority Set appliance 802.1p priority trunk Set trunking characteristics of the interface voice Voice appliance att

11、ributesSwitch(config-if-range)#switchport mode?mode Switch(config-if-range)#exitSwitch(config)#inSwitch(config)#interface f0/5Switch(config-if)#swSwitch(config-if)#switchport modeSwitch(config-if)#switchport mode ? access Set trunking mode to ACCESS unconditionally dynamic Set trunking mode to dynam

12、ically negotiate access or trunk mode trunk Set trunking mode to TRUNK unconditionallySwitch(config-if)#switchport mode trSwitch(config-if)#switchport mode trunk %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/5, changed state to down%LINEPROTO-5-UPDOWN: Line protocol on Interface Fast

13、Ethernet0/5, changed state to upSwitch(config-if)#exit項目實施過程及測試結果：1、銷售部PC1、人事部PC1、銷售部PC3、研發部PC1、研發部PC2、財務部PC等配置相關IP地址及子網掩碼等參數截圖 2、交換機配置信息（show running結果）一樓交換機SW1的配置： SW1>enSW1#show runSW1#show running-config Building configuration.Current configuration : 1276 bytes!version 12.2no service timestam

14、ps log datetime msecno service timestamps debug datetime msecno service password-encryption!hostname SW1!interface FastEthernet0/1 switchport access vlan 10!interface FastEthernet0/2 switchport access vlan 10!interface FastEthernet0/3 switchport access vlan 10! -More- 二樓交換機SW2的配置 SW1>enSW1#show r

15、unSW1#show running-config Building configuration.Current configuration : 1276 bytes!version 12.2no service timestamps log datetime msecno service timestamps debug datetime msecno service password-encryption!hostname SW1!interface FastEthernet0/1 switchport access vlan 10!interface FastEthernet0/2 sw

16、itchport access vlan 10!interface FastEthernet0/3 switchport access vlan 10! -More- 三樓交換SW3的配置 SW1>enSW1#show runSW1#show running-config Building configuration.Current configuration : 1276 bytes!version 12.2no service timestamps log datetime msecno service timestamps debug datetime msecno service

17、 password-encryption!hostname SW1!interface FastEthernet0/1 switchport access vlan 10!interface FastEthernet0/2 switchport access vlan 10!interface FastEthernet0/3 switchport access vlan 10! -More- 網絡中心交換機SW4配置SW1>enSW1#show runSW1#show running-config Building configuration.Current configuration : 1276 bytes!version 12.2no service timestamps log datetime msecno service timestamps debug datetime msecno servi